Another Aluminum Engraving


(Bill Johnes) #1

Heres another enclosure I engraved. Didn’t go as deep. Engraved depth .01" instead of .02".


(mark robinson) #2

Very nice Bill,Thank you for sharing :slight_smile:


(Richard Cournoyer) #3

Looks great, I think you found the correct depth. How did the cutters hold up this time?


(Bill Johnes) #4

Much better Rich but wore down a tad. I had to reset the Z once. I paid $20.00 for 5 so I still didn’t expect much. But I did just receive a good one from Tools Today along with a couple drill bits to drill starter holes for the switches, pots etc.


(Les Hall) #5

Did you paint the red color first?


(Bill Johnes) #6

Yes Les, I powder coated the enclosure first.