Controller board 2.4e

Hi, can somebody provide a pin layout diagram of the 2.4e version of the controller board?
I am looking to use the PWM out pin to control the spindle, and also use an e-stop/feed stop for the stepper motors. I just want to make sure I am using the right pins before soldering.

Thanks

1 Like

A blast from the past but still useful:

2 Likes

Do any of the 1.5KW spindles accept 1/2" bits or do you need the 2.2KW spindle for that?

I believe the 1.5kw spindles use ER11 but I don’t own one.

@Tomtomtom

What you seek is here…

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.