I’m not in front of my PC at the moment that has VCarve installed, but I did not hand edit the file, it is a function of VCarve. I think it’s at the bottom of the toolpath variables when you create it? Or maybe on the page where you define stock? I can picture it in my mind, but my mind is, well, not minding
The explanation for the “Rapid Z gap” is pretty obtuse. Theoretically If I do what is circled in Red I am ok although I will probably do “0.1” since the consequences (a slight gouge) are much less painful than what happens when the S03 hits the top and then goes completely nuts.