I just sent in a support ticket with this information but I figure I’d hit the forums too. I just purchased an SO3 XXL and I’m machining holes onto a wasteboard for work holding.
9.2 % into the job, the SO3 stops moving, and Carbide motion indicates that it’s on line 6809 of 74355. Ten seconds pass, I abort the job. It looks like Carbide motion was still connected to the SO3 because I did not receive any errors and I was still able to job the XYZ axis around.
Here’s the gcode along with the respective line numbers:
FWIW, I’m using a 1.5kw spindle. The spindle cable is shielded and grounded.
Any help from someone with more experience in the Shapeokos that I have is greatly appreciated.