Report G-code Line on Serial Failure


(Dan Periard) #1

I’ve noticed that when I have a serial comms failure, and the machine hangs, that I can’t see how far it got in the G-code when it failed. Could you have it report back the last G-code line sent before the failure occurred?


(Richard Cournoyer) #2

If you run Carbide Motion Ver 362, you can see (on the screen ) the GCode line.


(Dan Periard) #3

Thanks Rich - yes, when it’s operating normally, the G-code line is visible. My request would solve that when the serial communications fail (as it seems to happen randomly), I could still see the line number. See attached screenshot - this just happened. As you can see from the screenshot, there’s no feedback on where it got stuck.


(Kyle) #4

Yes this would be a nice future please!