Setting up a single-pass CAM job

Software
1

Probably a very simple question, but in Carbide Create, how would I make a single-pass cam operation? A la the “hello world test” that descends to a small depth, then runs a single pass. Would it be by setting the target depth for the operation and the pass depth to the same value?

Cheers!

2

Yes, if the depth per pass is equal to or greater than the specified cut thickness it will cut a single pass.

3

I’m still confused at the question.

4

Thanks Mr. Adams! I guess that was an easy one :slight_smile: I’ll figure up a more interesting question next go around.