Hi, I posted about my homing issue but noticed it was not on the support page and since I have not received any further info thought I’d try here. Every time I try to home the machine it goes to the back right hits the switch and comes back a quarter inch which I’m assuming is fine. The x axis goes to the right, hits the switch and travels back to the left about six inches. It should not go back that far should it? The GRBL code reads the same as the default values with exception of $14=1 (auto start, boo1).
Test Waiting…
___________$0=10 ___________
ok
___________$1=255 ___________
___________$2=0 ___________
___________$3=6 ___________
___________$4=0 ___________
___________$5=0 ___________
___________$6=0 ___________
___________$10=255 ___________
___________$11=.02 ___________
___________$12=.01 ___________
___________$13=0 ___________
___________$20=0 ___________
___________$21=0 ___________
___________$22=0 ___________
___________$23=0 ___________
___________$24=100 ___________
___________$25=1000 ___________
___________$26=25 ___________
___________$27=5 ___________
___________$100=40 ___________
___________$101=40 ___________
___________$102=40 ___________
___________$110=5000 ___________
___________$111=5000 ___________
___________$112=5000 ___________
___________$120=400 ___________
___________$121=400 ___________
___________$122=400 ___________
___________$130=425 ___________
___________$131=465 ___________
___________$132=80 ___________
Thank you,
Bill