X-axis slippage

[gmack (Gerald Mackelburg)]

@RichCournoyer

I have posted the mapping data (search under my name and (belt) calibration ), and learned that unless you have overstretched the belts (which is nearly impossible due to their construction) adjusting the steps per inch is not necessary; meaning the machine is just about as accurate as it can get. Making sure the machine is square and parallel is probably more important.

The belt research was to measure the difference in stretch and strength between the old 6mm vs the now standard 9mm (width).

Lastly, I have not looked into the Stepcraft data, so no comment.

OOPs - I forgot to insert this link to the Stepcraft data - sorry! Did you measure torsional stiffness?