X Limit Switch Shapeoko 3

[oldsurferjoe (Miles Baughman)]

X Limit Switch Shapeoko 3

Hi

Got the firmware updated and did jog and load humm sound and it looks like the X-Axis switch is not low enough to hit metal flange (see Picture)? Looks to be about a 1/4" short.

Z and Y contact and are fine.

Any help?

[jabberwocky (Chris C)]

I believe your switch is mounted upside down. Bolt through the top, switch at the bottom. Theres a good picture here: https://docs.carbide3d.com/assembly/shapeoko/xxl/step-6-wiring/

[oldsurferjoe (Miles Baughman)]

Darn it I think your right lol - THX

Yep lol - so silly!