Shapeoko


Topic Replies Activity
About the Shapeoko category 2 November 23, 2017
Cuts Off by 1mm? 27 August 4, 2020
More Aluminum Problems 4 August 4, 2020
Sticky Suckit Dust Boot Fixed 3 August 4, 2020
Dust shoe videos collection 114 August 4, 2020
1/8 bit won't reach, even with T Track on top 5 August 4, 2020
Can you run Shapeoko in a vertical orientation 20 August 4, 2020
Surfacing Aluminum without plunging? 6 August 3, 2020
Carbide Compact Router Plunge Base 8 August 3, 2020
Cut depth doesn't match settings 16 August 3, 2020
Carbide Compact Router - High Temps 8 August 3, 2020
V-Carve not deep enough 13 August 3, 2020
Vcarve stars problem 10 August 3, 2020
3D Printed Hose Routing and Dust Boot Hose Adapters for Shapeoko 42 August 3, 2020
Longer Length of Cut 12 August 3, 2020
Dewalt 611 Temperature Sensor Super PID 22 August 3, 2020
Tiling - First time 4x8' Workbench Top 16 August 3, 2020
Measuring belt tension, squaring and calibration 12 August 3, 2020
Temperatures (Fun with FLIR) 4 August 2, 2020
Z Axis not staying on 0 2 August 2, 2020
Acrylic wall finish tips? 86 August 2, 2020
V-Carve not re-producing a font correctly 20 August 1, 2020
T track + MDF: On top or in place of stock wasteboard? 27 August 1, 2020
Cnc4newbie Z upgrade issue - limit switch hit 11 August 1, 2020
HDZ Ballscrew Type 1 August 1, 2020
Is there a 24v Out pin (and nearby ground) on the Carbide Controller 2.4d board? 6 August 1, 2020
A mild case of OCD and an affinity for voiding warranties 3 August 1, 2020
Carbide T-track and Rockler clamps - INCOMPATIBLE? 11 July 31, 2020
Newbie question around vcarve 5 July 31, 2020
Shapeoko Fusion 360, carbide motion Z axis issues 2 July 31, 2020