Shapeoko Pro


Topic Replies Activity
About the Shapeoko Pro category 2 January 8, 2021
Securing the Shapeoko Pro to torsion table 2 January 20, 2021
Feed Hold Switch 22 January 19, 2021
Carbide Compact Router - there be sparks 2 January 19, 2021
Help with X-Motor Shaft and Belt Gear - Fixed 4 January 19, 2021
#201 bit barely touches bit setter 4 January 17, 2021
XL Availability 4 January 17, 2021
Upgrade to ShapeOKO Pro XL 6 January 17, 2021
Corner Square that attaches to Stock MDF Wasteboard Holes 2 January 17, 2021
New machine always asking for bit change loop 3 January 17, 2021
Getting the Pro Setup 18 January 16, 2021
Shapeoko Pro making horrible noise at first initialization 4 January 16, 2021
Rail and linear guide maintenance 8 January 15, 2021
Tool Change Location Not Consistent 5 January 15, 2021
Laseoko Pro Build Thread 44 January 13, 2021
201 Bit Broke - How should I adjust my settings 6 January 13, 2021
YL Motor Only Moving in one Direction 1 January 13, 2021
Confirm adjusting $102 z axis makes sense 4 January 13, 2021
Z axis going crazy 9 January 11, 2021
Shakeoko Pro Availability 3 January 11, 2021
Shapeoko Pro frame bolt down dimensions 15 January 11, 2021
Electronics enclosure 12 January 11, 2021
Z axis off using bitsetter 6 January 11, 2021
Shapeoko Pro - A very nice machine! 33 January 10, 2021
X-limit switch issue 17 January 9, 2021
X Axis skipping on first rapid to bitsetter 5 January 7, 2021
Shapeoko Pro Testing 9 January 6, 2021
Where can I get pro stepper motors 19 January 5, 2021
Updated timeline for Pro standard size? 2 January 3, 2021
Shapeoko Pro and 4th Axis / Laser 8 January 3, 2021