Shapeoko


Topic Replies Activity
More Aluminum Problems 13 August 4, 2020
Can you run Shapeoko in a vertical orientation 25 August 4, 2020
Has anyone used CC to kerf wood for bending? 75 August 4, 2020
V-bit settings carbide create 2 August 4, 2020
Cuts Off by 1mm? 28 August 4, 2020
Sticky Suckit Dust Boot Fixed 3 August 4, 2020
Dust shoe videos collection 114 August 4, 2020
1/8 bit won't reach, even with T Track on top 5 August 4, 2020
Surfacing Aluminum without plunging? 6 August 3, 2020
Carbide Compact Router Plunge Base 8 August 3, 2020
Cut depth doesn't match settings 16 August 3, 2020
Carbide Compact Router - High Temps 7 July 14, 2020
V-Carve not deep enough 13 August 3, 2020
Vcarve stars problem 10 August 3, 2020
Dewalt 611 Temperature Sensor Super PID 22 August 3, 2020
Tiling - First time 4x8' Workbench Top 16 August 3, 2020
Temperatures (Fun with FLIR) 4 August 2, 2020
Z Axis not staying on 0 2 August 2, 2020
Acrylic wall finish tips? 86 August 2, 2020
V-Carve not re-producing a font correctly 20 August 1, 2020
T track + MDF: On top or in place of stock wasteboard? 27 August 1, 2020
Cnc4newbie Z upgrade issue - limit switch hit 11 August 1, 2020
HDZ Ballscrew Type 1 August 1, 2020
Is there a 24v Out pin (and nearby ground) on the Carbide Controller 2.4d board? 6 August 1, 2020
A mild case of OCD and an affinity for voiding warranties 3 August 1, 2020
Carbide T-track and Rockler clamps - INCOMPATIBLE? 11 July 31, 2020
Newbie question around vcarve 5 July 31, 2020
Shapeoko Fusion 360, carbide motion Z axis issues 2 July 31, 2020
Endmill slipping 7 July 31, 2020
Z axis losing steps, belt tension issue 4 July 31, 2020