Software


MeshCAM Carbide Motion Carbide Copper Carbide Create This is for discussion of Carbide 3D's 2.5D design/CAD/CAM application Carbide Create. Please share your tips, tricks, and tutorials, or other discussion on it.
About the Software category [Software] (3)
CC Scrambles image when trying to center [Carbide Create] (3)
Change Table Size? [Carbide Motion] (2)
How to resume after feed hold in Motion [Carbide Motion] (8)
Weird thing happening with CC [Carbide Create] (6)
Z limit switch is broken for the second time by over travel [Carbide Motion] (8)
Carbide Motion 414 Worse Than 412 ( 2 ) [Carbide Motion] (25)
Shapeoko XXL , Carbide motion do not stop the spindle for me to install the tool ( 2 ) [Carbide Motion] (25)
Fusion 360 settings [Software] (1)
S3 XXL Header/Footer settings for F-Engrave [Software] (10)
Alarm state with UGS (SO3 XXL) [Software] (5)
Curious: What language is Carbide Create written in? [Carbide Create] (8)
Is there a way to do this in CC? [Carbide Create] (20)
Meshcam laptop minimum recommendations [MeshCAM] (4)
Carbide Create Closes On Its Own [Carbide Create] (2)
Copy object from one file to another [Carbide Create] (3)
Carbide create stopping abruptly [Carbide Create] (1)
Carbide Create importing only SOME dxf files [Software] (5)
V Carve Inlays Using CC [Carbide Create] (2)
Touch probe support for 1/2" bits [Carbide Motion] (4)
Snap to grid bypass? [Carbide Create] (7)
Spending too much time in Carbide Create? [Carbide Create] (4)
Can't figure out how to fix the rounded corners on the preview when doing V carving [Carbide Create] (12)
Carbide Create V-Carve not working properly for small bits? [Carbide Create] (12)
V carving Issues [Carbide Create] (3)
Only Curves show up when opening SVG [Carbide Create] (11)
CarbideCreate/Nomad cut size slightly wrong ( 2 ) [Carbide Create] (22)
How to add tools to Carbide Wizard in MeshCAM [MeshCAM] (7)
Anyone know where to find a Fusion 360 model of a Shapeoko 3 XXL? [Software] (2)
Change default Z offset from +6mm? [Carbide Motion] (10)