90°V bit help loading


(nick) #1

I try to load a 90° bit into the tool library and when I type in 90 for the degrees it shows up red and won’t load any tips?


(Mark Walker) #2

Depending on what software you’re using, it may want the taper angle rather than the tip angle which is half (45 degrees).


(Richard Cournoyer) #3

Watch the one on V carving, Should answer all your questions


(nick) #4

Im using carbide create


(nick) #5

Got it thanks guys I have to use half the degree of the bit so a 90 I have to type in 45