Advanced VCarve Inaly Line Width vs Depth

[mhotchin (Michael Hotchin)]

Your expectations are correct.

An area where the female part was full depth:

An area less than full depth:

From when the new Inlay mode was first posted:

Inlay Update in Carbide Create

This is my FIRST ever attempt at an inlay. The new mechanism seems to work very well. The only ‘special’ thing I did was I used a down-shear 60 deg bit instead of the usual 60 deg geometry. The inlay is about 5"x4.5". Ignore the hole in the center, that’s a problem with CM. A silhouette of a Welsh Terrier: [448601866_2913503888812693_5510745700937673294_n] Close-up around the head. The fit wasn’t noticeably different anywhere around the inlay. [448265459_833047025010097_22321961165952…