OK…here we go.
Initial&NewToolMacros.zip (1.9 KB)
After setting your Z zero, run the “Initial Tool” macro (be sure to edit probe location)
That will establish the tool offset for your probe.
When it’s time for a tool change, run the “New_Tool” macro.
Each macro is just one probe sequence with one tool. I don’t have a Nomad, but I think this it how it’s done. Will be great for multiple tool jobs.
Just remember to add probing wires when it gets to the probing location.
@patofoto
@PaulAlfaro
@Luke
@Griff
As always, would appreciate feedback.