BitZero V2 connection 3.5mm Jack no place to plug in?


I recently upgraded an old Shapeoko with the new controller board 2.4e and a BitRunner I am now looking to add the BitZero V2 and I notice in the picture on website it has a 3.5mm round jack and not a plug for the control board.

Anyone now what options I have for plugging this in to my control board?


The picture is an early one which shows a Nomad BitZero — you will receive a Shapeoko BitZero which has the correct Molex connector for a Carbide Motion Board.


This topic was automatically closed after 30 days. New replies are no longer allowed.