Carbide 3D Community Site

BUG - Pocket toolpath leaving section uncleared

Software Carbide Create

mhotchin (Michael Hotchin) April 7, 2024, 8:35am 4

Likely the same problem as here:

Bug - Pocket toolpaths using wrong stepover Carbide Create

The first step-over for a pocket path doesn’t respect the step-over setting for the bit. This is a 3/4" bit, 8mm step-over, grid is 10mm. The first stepover is clearly much greater than 8mm. [image] overlap test.c2d (44 KB)

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled