Carbide Motion, Feature Request, Setting Z Zero

Please consider adding an option to the Set Position window that tells the Shapeoko where to go after Z has been zeroed.

Right now, after zeroing Z the spindle always returns to the current X,Y. I would like the option to go to the tool change location after Z is zeroed.

Zeroing the Z is almost always the last thing that I do before starting the program so going back to the current X,Y uses up unneeded time and mileage.

6 Likes

I would like to 2nd this request

2 Likes

If this does get implemented, I would like to request a third option, “Park” - same location as end-of-program.

2 Likes

Ironically on my N4, when I click on the big red [STOP] button on the CM (667 at this point) interface, if the spindle is already at park, CM asks me if I want to park it before shutting down. If the spindle is not at park, it doesn’t ask, leaves the spindle where it is, and just shuts down. :man_shrugging:

1 Like

It is my understanding that this is getting looked at for v7:

3 Likes

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.