Carbide Motion no longer stops at the end to turn off router

[Jeffish (Jeff de Ruiter)]

Per my post in the thread you linked to… It’s not a bug.

@Jeffish

This changed and was brought up in a previous thread that is listed in the last link below. There were these other two threads started on it but I don’t think any action was taken to change it back to prompting for a router shutdown after a job completes and before homing the router.

https://community.carbide3d.com/t/prompt-to-turn-off-spindle-at-m05-if-no-bitrunner-spindle-configured/96024?u=jeffish

https://community.carbide3d.com/t/cm-648-beta-shutdown/91991?u=jeffish

In this one scroll down to Apr 5 post by Charles

https://community.carbide3d.com/t/carbide-motion-644-beta-now-with-program-restart/88624/62?u=jeffish