Change Code Restart

I’m sure there isn’t but I thought I’d ask anyway. Is there a way to edit my GCode and when I restart my job, start where I left off with the new code? What happed was, I kept old material thickness in my settings that were narrower than the .75 material I’m using now, so instead of cutting all the way through, it’s only cut to the previous thickness of .6875

You know, now that I think of it, I’d probably need to start all the way over anyway to cut all the way through the previous sections, because if I start where it is now, it won’t know to go back to the other cuts. Hmmm…

Yes. See:

Thanks for this Will. Did you guys get my support email about the controller?

I believe so. We only have 2 open tickets as of just now, and neither was yours — may be that it’s assigned to some specific person who will be in later today.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.