Have a wedding to attend in 2 days and figured I’d attempt this so looking for favorable criticism/ advice on setup for my 1st design in carbide create. Let me know what I need to change please. Attached are each pics of the 3 tool paths. Didn’t know if it would need a finishing path or if I should start out with a 1.5mm BN for the ring. This is going on a 21”x21” barrel head, other question without touch probe how to keep constant zero during tool change? Also any suggestions on how to get the rings rounded across top instead of flat?
Since you are new to this forum, you do not have the ability to post pictures yet
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.