Would be great if CM kept an eye on spindle commands to show the current “expected” RPM.
I have my homemade BitRunner, so I don’t get the popup that asks me to set the spindle to a specific RPM.
Sure, if I were going to set out to do a pretty involved job, or metal, I’d print up a Setup Sheet to track everything going on. But for making some elephant cellphone holders out of pine… eh. Less critical, and be nice to see what the last spindle command speed was to run my bits a little cooler.
If I’m really on my game paying attention I can catch the command when it first powers up before the move… but that is rare 