Cutter n0t found

Had my Shapeoko for about a year. Today it’s disconnecting after I click Initialize. It homes and then disconnects. I’ve replaced the cable. I’ve unplugged the machine for 10+ minutes in case it has some kind of refresh which I don’t think it does, but I did it anyway. I’ve rebooted the laptop I run it from. Took the cover off the board and made sure everything is plugged in, etc.

Really irritated now.

What’s next? Thanks in advance

Is this when you turn the trim router on?

Contact us at support@carbide3d.com and we’ll do our best to assist.

No, just initializing the machine. I’ll email, thanks.

This topic was automatically closed after 30 days. New replies are no longer allowed.