Carbide 3D Community Site

Depth First Pocketing, again!

Software Carbide Create

mhotchin (Michael Hotchin) October 20, 2024, 2:10am 7

BUG: Pocket operations cutting as slots Carbide Create

To prevent slotting, the usual advise is to cut a slightly oversize pocket instead. I have found a condition where the pocket is being cut as a slot - one path full depth, then the other, rather than alternating. It appears to be an interaction between a pocket cut followed by a contour cut. I first cut a pocket down to 1/8" off the wasteboard. Then I run a contour, with tabs, down to the wasteboard. Turtle Rock.c2d (596 KB) I think this CC file, with these two paths enabled, shows the pro…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled