I have set up my Shapeoko XXL, I made a basic star on carbide create, Saved the gcode, when I open Carbide motion and load the gcode, I get this error message.
did you select a post-processor in carbide create?
(it needs to be set to shapeoko)
1 Like
In Job set up I selected the machine Shapeoko XXL it also asks for retract height
can you go into “Edit -> Select Post Processor” ?
that also needs to say shapeoko
1 Like
I think I found what you are talking about it was in edit. I selected Shapeoko with homing switches
I am going to try it
Thank you
It worked thank you very much
This topic was automatically closed after 30 days. New replies are no longer allowed.