Fail homing after quit job

SO3 XL. Start a job with Carbide Motion, realize something wrong and use quit button in CM, which sets off automatic homing to back right, Y and Z home correctly, X stops 2inches or so short of the switch. Happens everytime and I have to close/reopen CM and turn my cnc off and on re-home and everythings fine.

Anyone have this problem or have a fix?

@lost57 Hi Brad,

Since your machine is the XL, most likely you will need to Update the $130 value to 840 in the GRBL settings.

Connect and Type $130=845 on the MDI line

For the full instructions on accessing GRBL settings:

1 Like

you were right, simple fix. it was set to 840. 845 fixed it. thanks :wink:

1 Like