Feedrate not increasing on texture path

[willhime (William Wade)]

I made a texture tool path. When I realized it was way to time consuming I changed the feed rate in aspire- 150”/min to 300”/minute. I messed with depth of pass, step over, etc in aspire.

Carbide motion showed my tool path as taking 59 minutes. So I increased the feed rate there as well and it gave me a time of 20 minutes.

After an hour, it said it time remaining 15 minutes.
2 hours later it said 10 minutes remaining.

Why is aspire and carbide motion not manifesting any of the changes I made ?

[WillAdams (William Adams (Carbide 3D))]

Most likely because the movements are so short in length that the machine can’t accelerate any faster.

If that’s not it, post the .c2d file

[Tod1d (Tod (with 1 'd'))]

The default max feedrate in CM is 5000mm/min (197"/min).

It’s likely calculating & reporting based on the programmed feedrate, but the actual path won’t go any faster, and the feedrate override won’t either.