I had unchecked both of those, but still getting problems because of the dropped I/J variables—when the value is zero it seems the post-processor doesn’t write it.
Also, I discovered that I can’t use lead-in/lead-out moves, and that’s what the whole G17/G18/G19 thing was about. If I get rid of the lead-ins and helical ramping, etc. it will take the file, however at the end of the program I get a G53 still, so I had to delete that out, then Carbide would take it.
About to try my tool paths from HSMxpress to see how they go. I’m concerned about the tool-change working correctly b/c of the tool-length sensor/tool-length definitions potentially conflicting.
I’ll keep you posted as to if this works.