GRBL software Setup

I’m looking for help I’m new to this and asking for assistance I have a engraver that uses grbl software I can’t seem to get the steppers to move I’ve tried everything I’ve been on the internet for the last 3 days but nothing made sense I suppose its in the setup so I would appreciate any help.
Thanks

Sorry to hear about this difficulty.

Most folks here use Carbide Motion boards which (mostly) “just work”, since the discussion here is about Carbide 3D machines.

I believe you’ll have better luck on the old Shapeoko forums which are a bit more open, and for which arbitrary boards running Grbl is on topic:

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.