How do I use Zero 3 probe in Motion?

Good morning CNC Gurus! I’ve been using CNCjs since I started… now I’d like to experiment with Carbide Motion (js is too “programmy” for me). The deal is, I am at the point of the probe and cannot figure out what to do if I have Luke’s Zero 3 probe (the one with the big hole in it). Seems simple, but I’m old and have a hard time learning new tricks. This may have been covered already, but i cannot find instructions. Thanks in advance for advice. WOOT!

I figured out how to probe without using the hole.

1 Like