Lightburn macros

[Julien]

I have been using those two macros to switch in and out of laser mode

Laser settings on shapeoko

Yes, the macro needs to have at least three lines in it. one line for setting $32 to 1 one line for setting $10 to 0 one line for adjusting G10 L2 P1 coordinates Here’s a copy/paste of the text in my “Configure for laser” macro. I have one extra line for setting $20 to 0, which disables soft limits: in my setup I was getting errors when soft limits were enabled, so I added that line, it won’t necessarily be required for you) $32=1; enable laser mode $10=0 ; to get positions displayed as posi…