Limit switch error recurs

I have a NOMAD 3. I get the Limit switch error message from time to time- I thoroughly clean the machine (vacuum and blow out) and that seems to take care of the issue until the next time. What is the limit switch and what to do other than what I’m doing? I don’t think you can cent er the NOMAD manually, can you?

thx cjhash

The switches are used at the top right and furthest back travel points to home the machine.

The center Rapid Position point should be quite close to the physical center of the table.

This topic was automatically closed after 30 days. New replies are no longer allowed.