Guys??? Is there a hack or easy way to get the limit switch wires (I’m replacing all of them} to the control board or do I have to literally open up the cage clips the whole trip?
Tape the new ones to the old ones and pull them through?
1 Like
Lol…DANG! I wish I would have thought of that. I’ve already been going through poppin’ clips lol. Thanks man, Will have ta remember to try that if I’m in this situation again
Just dont pull too hard. Those wires are delicate. The pulling method would work but pulling the tabs off the drag chains may be safer.
2 Likes
Yep. And that’s the route I went. Super Delicate, Clip Poppin, 2 Miles of chain route lol
Naa, it wasn’t Absolutely Horrible, just…Tedious AF