I’m confused because I can’t see a manual way to initiate a homing cycle e.g. a homing button.
On the few occasions (
) that I’ve had to redo the homing, I’ve either cycled the Shapeoko power or restarted CM. The latter means also makes me reload my file.
What am I missing?
You can always go to the console window and type in $h and return to execute the homing cycle
So, its that simple and yet there’s no programmatical method provided?
Sheesh, what will they think of next?
There may be a way. I don’t us Carbide Motion so not sure if all the ins and outs but there is the console option for initiating GRBL commands manually.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.