New and about to place order

[WillAdams (William Adams (Carbide 3D))]

I added a vertical plate on the right underside of the table my SO5 Pro is on and bolted the controller there as shown at:

Mounting the electronics for an SO5 Pro

Needed to mount my SO5 Pro control box out-of-the-way — while the dimensions were given in: the hole locations were not. Here’s a template I worked up — YMMV, please check against your box, &c. so5_electronics_template.pdf (1.1 KB) which worked for me: [image] [image] [image] [image] and the MDF was screwed to one side of the base of my workbench.

The same approach should work for the VFD on the opposite side.