Merick01
(Maurice)
1
Need some advice,
I burned up a 1/8” Spiral Down Cut plunging holes for the cribbage boards.
I know I should have been using a up cut, which I have now.
What RPM speeds should I use, default is 18000, but I think I should dial it back.
I’m doing a plunge chip breaking (pecking) tool path.
Any suggestions?
mhotchin
(Michael Hotchin)
3
This looks like a not bad deal - pins, plus a ‘drill mill’
1 Like
system
(system)
Closed
4
This topic was automatically closed after 30 days. New replies are no longer allowed.