“Probing Cycle Failed”

Completed assembly of my new 3xxl. Have powered on the machine, connected to the cutter, and initialized the machine. A side note: I am using Motion 5. The machine goes through initialization (as described in the setup document) but when it returns to home the spindle travels all the way to thew bottom of the z-plus, chatters, shuts down, and gives me a “Probing Cycle Failed”.

Anyone have any suggestions?

Help will be appreciated.

Do you have a BitSetter?

If not, did you check the box for a BitSetter? If so, please uncheck it.

If that’s not it, let us know at support@carbide3d.com

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.