Probing Upper left corner

Will there soon be a built in way to prob the upper left corner with Carbide Motion?

I know this has been discussed before, but I’m wondering if this function will soon be built into the Carbide Motion software?

In my case I often mill on pieces that extend out the front of my XXL Shapeoko. With the fact that I have a solid enclosure with only a front opening, extending the stock out the back of the S3 is not an option.

Well, I have asked for all FOUR corners to be a possibility…when the probe first came out…so I would presume it is not going to happen “soon.”

I added a hinged back so that I could slide it out the back. Just saying…

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.