Rapid position but no manual jog

1

Hello,

Today I fired up the shapeoko to start a routine project but can’t seem to manually jog. I can rapid position successfully in all positions but can’t manually jog it to where I need it to go. It shows “busy” in motion when I am trying to jog but no movement. I have tried in all the speeds from slow to fast but no success…

TIA

2

What’s your jog increment set to?

1 Like
3

i’ve tried all speeds from slow to fast

4

What are the Travel Dimensions under Settings?

5

travel dimensions are 830 x 850 x 95

6

problem has resolved itself after i rebooted everything.

thank you for your responses!

7

This topic was automatically closed after 30 days. New replies are no longer allowed.