S3 XXL doesn't see full cut area

Hi everyone!

I just turned on my machine for the first time in a couple months and when I did rapid position to the bottom left corner, it just stopped about in the center. It was acting like that is the bottom left corner. I looked through carbide motion and didn’t see anything to set the machine size.

It was successful to do the machine honing to the back right corner. So I knew it could see the limit switches.

Thanks!

Please check/re-send the machine configuration.

If using CM4 and Grbl 1.1: https://docs.carbide3d.com/support/carbideupdater/#carbide-motion-v4

If using CM3 and Grbl 0.9: https://docs.carbide3d.com/software-faq/shapeoko-3-default-grbl-settings/ and https://docs.carbide3d.com/shapeoko-faq/shapeoko-enable-homing/

2 Likes

Thanks Will back to normal! No idea how I missed that setting :frowning: I feel stupid!

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.