Stumped and already contacted support but wondering if anyone ever had these tiny screws, brass looking, fall out of the 65 spindle?
Also piece of metal bracket fell out and got caught in the bit. Chewed it all up. Looked and examined spindle and seems like too small for the outer screws. Ideas?
Might help if you specified what machine you are using.
Looks like it could be the clamp holding the wire at the top of the spindle connector.
Bingo! That’s what it was. Thanks for looking into it. I thought it was from inside spindle. Have two commissions and was freaking out I wouldn’t get them done on time as I didn’t dare operate it agains. Thanks!
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
