I think the point is that this information should be published as a diagram on the website so buyers clearly know what they are getting. No-one said that it was not factual but if you plan is to use the machine to produce something of a size close to the max, you may have to use workaround (e.g.: tiling) to do it and that may require additional software and time to produce. Usually not an issue for one of but could make a difference for someone producing commercially. For example, I ruined two wasteboards and a fair bit of time trying to drill pocket holes for T nuts near the perimeter and had to contact support to get this information. I would have planned the work differently if the documentation had been clear from the start.
1 Like