Yesterday I did a project which I created with Fusion 360. I tried to create a ring from beechwood, but the result was very bad. So I did the same project with CC (413) because I thought that I did something wrong selecting speed and feed.
Today I try to machine this project but run only in trouble.
First the machine stops in the middle (line 3095).
After a power cycle of the machine and a restart of CM (416) the machine was detected, but starting the homing cycle the connection gets lost.
2. try the same, 3. try: it works till line 1037.
Afterwards same behavior as before
Has somebody an idea what I can check ? Machine is only some month old and not used very often. PC is only used for the CNC.
LedHolzCC.nc (102.8 KB)