Stepper Resolution Shapeoko 4

[WillAdams (William Adams (Carbide 3D))]

Folks have used Shapeokos for PCBs, but the Nomad is better for this, and capable of a finer trace width.

There was a fair bit of discussion of this on the old forums:

https://forum.shapeoko.com/viewforum.php?f=28

and see:

PCB on the Shapeoko

Hi all looking for a little help on some speeds and feeds. Does anyone have experience with Copper clad FR4 on the Shapeoko? I need to cut my first PCB and it’s 1/8" single side copper clad FR4 Here is a Link. I was planning on using a .03 ball engraver from Lakeshore, with a DOC of .01" for the traces. For the holes, and to release the part form the stock, I was going to use a 1/16" 2 flute from Kodiak with a DOC of 1/8".