Touch Plate set up

(Wilbert B Pino) #1

Hi,
I recently upgraded my Z axis to the Beaver HDZ. I am trying to figure out how to set up macros to use my CM touch probe for tool setups other than solely the Z axis. Are there any routines out there? Right now I have been using UGCS and CNCJ built-in Z probe routines without any issues. I would like to use it to find the X Y coordinates as well. Thanks

0 Likes

(system) closed #2

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.

0 Likes