Traveling 2x farther then it says after grbl 1.1 flash

Hi all,

I upgraded to grbl 1.1 and pushed the shapeoko 3 parameters to my unit and now am getting a weird issue with axis travel. After homing to the switches I asked it to rapid travel to the center of the board, but instead if ran all the way across the gantry and stopped by the far left side. The Jog / Position only registers X: -210 Y: -145 Z: -5 when it should be registering twice that… I have looked at the log file and nothing is amiss from the default except the $130 & $131 values were wrong from the original parameters push.

Do you have an older board with DIP switches?

If so, power down and change them from 4x micro-stepping (the original default) to 8x micro-stepping (the current default)

3 Likes

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.