A couple years ago I updated to GRBL v1.1 with success. Recently I tore down the machine to move it to a new location, and install the HDZ while at it. I figured I would re-update in case the newest updater included some of the newer v1.1 stuff (mine is 2017 something). But after holding the Z limit switch and starting the update, it just sits at the Updating Firmware window and never progresses. I let it run for at least 5min on one go.
I confirmed that Carbide Motion still works fine (was worried I had bricked my controller). Any ideas here?
I was interested in updating again because since upgrading to v1.1, there have been a few minor releases of v1.1 over the months, seen here https://github.com/gnea/grbl/releases. Didn’t know if the Carbide Update included any of those updates.
It could very well be that Carbide Updater has not included any of these newer updates, and I am on the latest that carbide supports. I wanted to check and see.
I’m afraid that we haven’t updated the updater with a new version of Grbl since we first updated to 1.1 — when we do, there should be a big announcement on the blog, and a new carbideupdater app.