Variables for cut depth, etc

Hello!
I didn’t see this mentioned, but I might have missed it. I would like to have 1-to-X number of variable fields available in the project settings. There, I could set numbers that I could then use in certain fields throughout the design, so that when I want to change one of those numbers, I could change one place and have it apply everywhere. It would need to recalculate toolpaths when changed, of course. Ideally it would be a prompt that comes up when clicking in relevant fields (cut depth being the most obvious), but typing in a variable like $1 would also be fine.

Thanks!

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.