Love this now i have to incorporate with my stuff I hate trimming g10 down to fit In the flip jig.
Two low profile vises arrived and I discovered that they can both be mounted to the stock platform/table via the threaded holes in the extreme corners. They fit in both directions, along x or y. About a 1/4 of the vise hangs over the edge of the platform.
Requires two M6x15mm cap screws per vise. There is just enough slack in the drilled holes in the vise to allow fine alignment.
2 Likes
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.